Smith Machine MA50

• This weight machine is a training device in accordance with EN ISO 20957-1/2:2024 Class H. Maximum permissible weight for the barbell is 200 kg
• Max. Max. load capacity for the pull-up bar 130 kg.
• The weight machine may only be used for its intended purpose!
• Any other use is unauthorised and potentially dangerous. The importer cannot be held responsible for damage caused by improper use.
• You are training with a device that has been designed in accordance with the latest safety standards. Possible sources of danger that could cause injury have been eliminated as far as possible.

To avoid injuries and accidents, read and observe the following rules:

1. Do not allow children to play with or near the appliance.

2. Check regularly that all nuts and bolts are tight.

3. Replace defective parts immediately and do not use the appliance until they have been repaired. Pay attention to possible material fatigue.

4. Read the operating instructions in full before using the appliance.

5. The appliance requires sufficient clearance in all directions (at least 1.5 m).

6. Place the device on a firm and level surface.

7. Do not exercise immediately before or after meals.

8. Always have yourself examined by a doctor before starting training.

9. The level of safety is only maintained if the wearing parts are checked regularly.

10. Never use training equipment as play equipment.

11. Always wear shoes when exercising, never exercise barefoot.

12. Make sure that there are no other people in the vicinity, as they could be injured by moving parts.

13. The device must not be used in damp rooms or on balconies.

14. Only use Olympic weight discs with an internal diameter of 50 mm for the multi press.

15. Always secure the weight discs with the safety springs.

16. When putting on or taking off the discs, use both hands and distribute the weight evenly to the left and right.

17. Additional weight discs can be stored on the holders provided.

18. In addition to the training area, a free space of at least 0.6 m is required.

19. This free space must cover the emergency descent zone.

20. Adjacent equipment may share the free space.

The area of application of this training device is the home area. The device complies with the requirements of EN ISO 20957-1/2:2024 Class H. Improper use of this device (e.g. excessive training, incorrect settings, etc.) may result in damage to health.

Before starting training, a general examination should be carried out by your doctor to rule out any existing health risks.